Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure. Lap joint construction with a self-adhesive, EVA foam gasket (included) for the lid provides protection against access of dust and water. If you do not require the gasket – link to our non-watertight version 1550 series. Unpainted version is vibra finished for a smooth surface with no sharp edges.
Painted version is painted with tough – satin black polyester powder paint for a lasting finish, even after machining. Black screws are included to enhance assembled appearance. Four M3.5 x 0.6 x 12 mm long stainless steel, Philips head, machine screws secure lid – into factory tapped holes. Replacement screws for the unpainted series – 1550MS100 – Package of 100 Replacement screws for the black series – 1550MS100BK – Package of 100 Designed to meet IP 66 (with properly installed included gasket and lid screws torqued at 55 cN.m).
Upgrade gasket kit to IP 67 also available (see below) No internal ribs for easy installation of connectors without interference or additional milling. Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.